yuriy/joplin-mdbooks-website
1
0
Fork 0
Code Issues 11 Pull Requests Packages Projects Releases Wiki Activity

Update

Browse Source
This commit is contained in:
Stavros Korokithakis
2020-11-30 05:21:36 +02:00
parent a194417a41
commit fc01655a28
13 changed files with 86 additions and 22 deletions
Download Patch File Download Diff File Expand all files Collapse all files

12
content/model-build-notes/build-notes-for-the-ft-mighty-mini-arrow.md
View File

@@ -14,14 +14,14 @@ These notes are a condensed version of the [FT Arrow build video](https://www.yo
* Do an "A" fold on the spars and glue, stop 15mm from each edge. Use a triangle to make sure the spar folds are perpendicular.
* Open the servo hole.
* Cut the bevels, double on wing and single on elevon (on the elevon side).
* Add a thin ribbon on glue on the bottom of the hinge for strength, and scrape almost all of it off.
* Add a thin ribbon on glue on the bottom of the elevon hinge for strength, and scrape almost all of it off.
* Remove servo pocket from the wing.
* Fold the wing with the bottom on top, to curve the leading edge without crinkling the airfoil score cuts.
* Cut the side pods if you aren't going to use a center pod.
* Glue the side pod hinges.
* Cut the main pod space on the top of the wing.
* Skewer the wing score cuts.
* Line up the spar's servo hole onto the wing and glue.
* Line up the spar's servo hole onto the wing and glue onto the top side.
* Glue the airfoil's score cuts and fold the wing so the score cuts are glued up.
* Cut the excess spar.
* Probably put the servos in now, to avoid having to make a hook later.
@@ -40,7 +40,7 @@ These notes are a condensed version of the [FT Arrow build video](https://www.yo
* Pop out the tabs on the center pod.
* Do an "A" fold on the bottom plate.
* Fold the little edge of the top of the center pod over (and/or add tape).
* Glue the center pod on.
* Glue the center pod on. The backs of the wing should both be at the same height. Note that still be open/exposed, not glued down. FT leave them like that, but I like to close them up with some tape at the end so junk doesn't get into the wing.
* Install the control horns and servos (I use epoxy for the control horns as they tend to get ripped out with just hot glue).
* Use the reflex checker foam to calibrate the wing's reflex.
* Add a ziptie to the control rod so it doesn't bend.
@@ -64,4 +64,8 @@ These notes are a condensed version of the [FT Arrow build video](https://www.yo
## Electronics
* The rest is left as an exercise to the reader.
* The rest is left as an exercise to the reader.
* * *
Last updated on 2020-11-27 17:22:29.

6
content/model-build-notes/mini-drak-build-condensed-instructions.md
View File

@@ -52,4 +52,8 @@ To start building:
Notes:
> Make sure you use the tallest control horns possible and have loads of expo in for the roll axis (pitch is fine). Matt (because the MD is very roll sensitive as I found out to my surprise).
> Make sure you use the tallest control horns possible and have loads of expo in for the roll axis (pitch is fine). Matt (because the MD is very roll sensitive as I found out to my surprise).
* * *
Last updated on 2020-11-27 00:10:22.