joplin-mdbooks-website/content/model-build-notes/build-notes-for-the-ft-mighty-mini-arrow.md
Stavros Korokithakis 9054b27750
Style updated date
2020-11-30 14:49:56 +02:00

3.0 KiB

+++ title = "Build notes for the FT Mighty Mini Arrow" weight = 0 sort_by = "weight" insert_anchor_links = "right" +++ These notes are a condensed version of the FT Arrow build video.

maxresdefault.jpeg

Wings

  • Do an "A" fold on the spars and glue, stop 15mm from each edge. Use a triangle to make sure the spar folds are perpendicular.
  • Open the servo hole.
  • Cut the bevels, double on wing and single on elevon (on the elevon side).
  • Add a thin ribbon on glue on the bottom of the elevon hinge for strength, and scrape almost all of it off.
  • Remove servo pocket from the wing.
  • Fold the wing with the bottom on top, to curve the leading edge without crinkling the airfoil score cuts.
  • Cut the side pods if you aren't going to use a center pod.
  • Glue the side pod hinges.
  • Cut the main pod space on the top of the wing.
  • Skewer the wing score cuts.
  • Line up the spar's servo hole onto the wing and glue onto the top side.
  • Glue the airfoil's score cuts and fold the wing so the score cuts are glued up.
  • Cut the excess spar.
  • Probably put the servos in now, to avoid having to make a hook later.
  • Glue the leading edge, bottoms of the spar, and the end of the trailing edge, and press closed.

Joining the wings

  • Tape the wings together at the bottom, glue them together in the middle, lay them down and wipe the excess glue.
  • Cut the excess edge of the nose.

Center pod

  • Pop out the foam tabs on the wings, where the center pod will go.
  • Pop out the tabs on the center pod.
  • Do an "A" fold on the bottom plate.
  • Fold the little edge of the top of the center pod over (and/or add tape).
  • Glue the center pod on. The backs of the wing should both be at the same height. Note that still be open/exposed, not glued down. FT leave them like that, but I like to close them up with some tape at the end so junk doesn't get into the wing.
  • Install the control horns and servos (I use epoxy for the control horns as they tend to get ripped out with just hot glue).
  • Use the reflex checker foam to calibrate the wing's reflex.
  • Add a ziptie to the control rod so it doesn't bend.

Power pod

  • Install the motor onto the power pod and install the power pod. You probably don't need to glue this, just make sure it's tight.
  • Remove the foam from the sides of the nose.
  • Do a "C" fold on the back bit (and probably add some tape).
  • Carefully bend the nose.
  • Test fit it and glue the front part.
  • Use more tape to secure the front and sides.
  • Add some tape so you can pull the top open.
  • Add some glue to the bottom of the top hatch so it catches and secures on close.

Winglets

  • Only cut the top part of the wing, parallel to the bottom.
  • Line up the reference line on the winglets and glue (the front tip of the winglet should be flush with the leading edge).

Electronics

  • The rest is left as an exercise to the reader.

Last updated on November 27, 2020.